Triple moulds for preparation of prism shaped samples

Triple moulds for preparation of prism shaped samples

Application
Preparation of prism shaped samples, 40x40x160 mm
made of mortar, especially cement mortar in accordance
with the standards EN 1961, ISO 679, DIN EN 128084,
EN 101511 and ASTM C 348. Design and accuracy
according to the schedule „Technical Data“.
Design
Precision design in high quality steel.
The mould parts, consisting of head ends and separation
bars, are fixed on the cast iron base plate using a clamp
screw and counter bearings. High precision keyseats
tighten the joints between parts during compacting.
The compliance of the size tolerances to the respective
standard can be certified on request.
Advantages
–    head ends and separation bars are seperately marked
to secure the fitting
–    a tommy screw enables precise pressure without
wedging the parts
–    the design of the base plate and the surface finishing
avoid a deformation of the mould
–    by use of a brass straight edge the mould guarantees
the required dimensional stability longtermed
–    the mould is available alternatively with or without
holes for shrinkage tests
–    compatible with all components of the ToniLAB
–    because of the small weight tolerances the mould is
adaptable to instruments of other manufacturers
Available Models
Mould, model 6012
for prisms 40x40x160 mm according to EN 196-1,
ISO679, ASTM C 348; made of steel;
Mould, model 6012.50
for prisms 40x40x160 mm according to EN 196-1,
ISO679, ASTM C 348; made of stainless steel;
Mould, model 6021
for prisms 40x40x160 mm, according to DIN 1164-7 and
EN101511; made of steel;
All models are available with or without holes for shrin
kage tests (see „Technical Data“).